Subaru 30,000 Mile Service Schedule
Perform at 30,000 Miles, 90,000 Miles, etc
- Replace engine oil, filter and drain plug washer
- Inspect and adjust all drive belts to factory specifications
- Inspect and ensure cooling fan is operating within factory specifications
- Inspect transmission fluid
- Check to ensure air conditioning and heating systems are operating within factory specifications
- Rotate tires, inspect tread wear and check and adjust tire pressure as needed
- Perform brake system inspection; pads and/or drums, lines, hoses and fluid
- Inspect suspension system and steering components to ensure factory specifications
- Inspect battery and clean terminals, check battery condition
- Inspect wiper blades and linkage operation
- Lubricate all door, trunk and hood latches and hinges if needed
- Inspect exhaust system and heat shields
- Inspect front and rear differential fluid
- Inspect radiator and cooling system
- Adjust emergency brake to within factory specifications if needed
- Replace air filter element
- Inspect steering operation, tie rod ends and steering rack guides per factory specifications
- Inspect all engine and transmission mounts
- Inspect and adjust all fluid levels as needed
- Check all interior and exterior lighting operation
- Replace brake fluid
- Factory trained technician to conduct road test
- Replace Pollen Filter every 12,000 miles (if equipped)
- Replace engine coolant and test protection levels
- Replace fuel filter on 2004 and older vehicles only every 30,000 miles
- Replace non-platinum spark plugs 2004 and older every 30,000 miles
- Replace platinum spark plugs 2005 and newer on 4 cylinder engines every 30,000 miles
